[time-nuts] Distribution amp - Use a video amp unit ?

[paul swed]

Thats the RGB amps I have used the Extrons. Its in the basement and worked
very well.
Could not remember the name.

On Sun, Mar 25, 2012 at 4:02 PM, cfo <xnews3 at luna.dyndns.dk> wrote:

> On Mon, 26 Mar 2012 08:11:16 +1300, Bruce Griffiths wrote:
>
> > Bruce Griffiths wrote:
>
> > A circuit schematic for a current feedback triple with reasonably low
> > noise and distortion is attached.
> >
> > Bruce
>
> Thanx Bruce
>
> I'm an analog noob , so i have some questions.
>
> If i multiply that schematic by 8 , could i then just add the Tbolt input
> at all V1's ?
>
> Should R15 + C11 + C12 also be multiplied ?
>
> Is V2 a 12v supply (i suppose so) ?
>
> Could i replace the 2N3904 with BC850LT1 (smd) , and the 2N3906 with
> BC856ALT1 (smd) , else i have some BC337/BC327 - TO92 (non smd)
>
> Would one chan work on a perf-board with wires (proof of concept) , or
> would it be to "RF sensitive" ?
>
> regards
> CFO
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>