[time-nuts] Trimble SCPI commands

Azelio Boriani azelio.boriani at screen.it
Thu May 31 17:18:08 UTC 2012


>From the Apr 2012 post:

Power Supply:
The NTGS50AA requires 36-75 VDC (48V nominal) and has a on-board Lucent
DC-DC
converter to supply the required +/-12 and +5 volts.

Serial Interfaces:
Port A is RS-422 @19200 SCPI (available on the 110 pin connector on the
main
board)
Port B is RS-232 @9600 TSIP (DB9 connector on Breakout board)

LED indicators:
There are 5 LED's on the breakout board that contains the DB9 connector.
1. Power
2. Not used, but switch-able via software
3. Not used, but switch-able via software
4. Lock
5. Holdover

Temperature Sensor:
DS1620 Rev D

Jumpers:
There is a 8 pin header (JP1) on the main board that would accept 4
jumpers.. I
haven't tried them but it is tempting to see what happens when I enable
them.

On Thu, May 31, 2012 at 7:05 PM, Skip Withrow <skip.withrow at gmail.com>wrote:

> Hello time-nuts,
>
> Does anyone out there have information on the Trimble SCPI commands for
> units manufactured for Nortel (such as the NTGS50AA)?  I have a unit that
> has a DB-9 that talks SCPI. The *IDN and *CLS commands work, but I have not
> been able to get anything else out of it.  I have not found the TSIP port
> in the unit yet (if there is one).
>
> Thanks in advance.
>
> Skip Withrow
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>



More information about the Time-nuts_lists.febo.com mailing list