[time-nuts] HP 10811A failure
Tom Knox
actast at hotmail.com
Sat Oct 13 14:34:05 UTC 2012
Sounds like another dead cap.
Thomas Knox
> Date: Sat, 13 Oct 2012 14:51:54 +0200
> From: rfnuts at arcor.de
> To: time-nuts at febo.com
> Subject: [time-nuts] HP 10811A failure
>
> Hi All,
>
> both of my double oven 10811A's have been running flawlessly until now
> when I noticed that the output power has dropped by about 3 dB (measures
> only 4...4.5 dBm at 50 Ohm load), and the noise floor has gone up by
> about 20 dB, while the frequency is still spot on.
>
> I used them for various mesurements, so I can unfortunately not remember
> what might have caused the failure. Only the 12V linear lab power supply
> that fed the heaters had developed a completely dead filter cap, so the
> feeding voltage was a 100 Hz sawtooth rather than DC. The heaters appear
> to be still working though. I'm only using the internal heater. They
> draw some 700 mA at power up and drop to around 150 mA each when warm.
> So the oscillators are unlikely to be cooked inside. Something must have
> happened to the 10 MHz output, possibly an ESD issue?
>
> Before I start taking them apart, can anyone tell what has happened or
> what to look for first?
>
> Regards,
> Adrian
>
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list