[time-nuts] HP Z3805A com port and monitoring questions

[Edgardo Molina]

Dear Said,

I am having a very hard time trying to guess the communication port configuration of the HP Z3805A. I am trying with different port settings to match the PC and using different monitor and control programs. The afternoon was not that fruitful regarding this. Is there a chance you have the default port configuration for the Z3805A so I can match my PC serial port configuration?

I might be unavailable to respond to you tomorrow during the day, as I will be at Queretaro with restricted access to the Internet. Despite this I will be able to read my mail, not respond to it. Hope you don't mind.

Your kind help is always welcome. Thanks.

Regards,



Edgardo Molina
Dirección IPTEL

www.iptel.net.mx

T : 55 55 55202444
M : 04455 20501854

Piensa en Bits SA de CV



Información anexa:




CONFIDENCIALIDAD DE INFORMACION

Este mensaje tiene carácter confidencial. Si usted no es el destinarario de este mensaje, le suplicamos se lo notifique al remitente mediante un correo electrónico y que borre el presente mensaje y sus anexos de su computadora sin retener una copia de los mismos. Queda estrictamente prohibido copiar este mensaje o hacer usode el para cualquier propósito o divulgar su en forma parcial o total su contenido. Gracias.


NON-DISCLOSURE OF INFORMATION

This email is strictly confidential and may also be privileged. If you are not the intended recipient please immediately advise the sender by replying to this e-mail and then deleting the message and its attachments from your computer without keeping a copy. It is strictly forbidden to copy it or use it for any purpose or disclose its contents to any third party. Thank you.





On Oct 14, 2012, at 11:05 PM, SAIDJACK at aol.com wrote:

> Hi Edgardo,
> 
> I think the Z3805A and 58503A are identical, except in the rubber bumpers,  
> maybe the power supply voltage setting, and the ID string..
> 
> I don't really care, the three units I have perform much better than  
> anything else I have, so that satisfies my requirements..
> 
> In fact one of the units' ADEV can only be qualified by the BVA 8600  o
> scillator I have, and I don't know if I am measuring the BVA performance or the  
> 58503A because I am measuring right at the specification of the BVA unit.. 
> Wish  I had two BVA's :)
> 
> bye,
> Said
> 
> 
> In a message dated 10/14/2012 15:41:25 Pacific Daylight Time,  
> xe1xus at amsat.org writes:
> 
> Derived  question: Will I get better GPSDO performance if I use a 58503A 
> receiver? Or  do you think our units match those 58503A GPSDOs out there?
> 
> Again,  thanks to everybody who helped me to figure out about my receivers 
> and their  inner workings. As always, you all made my day. 
> 
> 
> Best  regards,
> 
> 
> 
> Edgardo Molina
> Dirección  IPTEL
> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.