[time-nuts] Z3801 Replacement GPS Receiver Card
GandalfG8 at aol.com
GandalfG8 at aol.com
Thu Sep 13 19:56:20 UTC 2012
I found an online comment some while ago that suggested non of the later
receivers would work, again it's something I haven't tried but I suspect the
message formats are incompatible.
Following my earlier post it would seem that an 8 channel VP should indeed
be ok if configured to be in 6 channel mode, see Time-Nuts archive for
March 2007, but although I knew the six channel version was hard to find these
days I hadn't realised that now also applies to the later 8 channel
version, so perhaps not such a useful suggestion after all:-(
Regards
Nigel
GM8PZR
In a message dated 13/09/2012 19:00:53 GMT Daylight Time,
albertson.chris at gmail.com writes:
Really? It can't use the newer UT? I thought the UT is identical except
for better performance. The even newer MT type are 3 volts and couldent
work but a UTshould be a drop in fit. But then I never had a Z3801. I
use the Oncore receivers directly
Chris Albertson
Redondo Beach, California
More information about the Time-nuts_lists.febo.com
mailing list