[time-nuts] Symmetricom 58532A and 58536A group delay figures
John Ackermann N8UR
jra at febo.com
Sun Sep 30 15:30:07 UTC 2012
Found the data on the splitters:
http://www.febo.com/pages/lab_documentation/gps_cable_delay/hp_gps_splitter/
My recollection was a bit off -- we saw about 22ns on the two-port 58535a and about 15ns on the 8-port 58517A. I would guess the 4-port unit would be similar.
Unfortunately, I haven't been in a position to try to measure the delay through an antenna.
John
----
On Sep 30, 2012, at 2:51 AM, Christopher Brown <cbrown at woods.net> wrote:
>
> Assuming it does not snow again, should finish the cabling to the new
> rooftop tripod and switch to the new antenna and splitter tomorrow.
>
>
> For the LMR400 main run and jumpers is simple enough, will just measure.
>
>
> That leaves the antenna and splitter, both have and amp and bandpass
> filter and I am assuming a combined delay that is likely greater than
> the cable delay given the short runs.
>
>
> Nothing is listed in the datasheets, but they are the semi-marketing
> sheets (only a couple pages) rather than a proper datasheet.
>
>
> Anyone know what the delay for this amp and splitter is? Or better yet
> a delay v.s. temp plot?
>
>
> Thanks
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list