[time-nuts] Question about FTS 1050A
Tom Knox
actast at hotmail.com
Thu Apr 4 04:22:42 UTC 2013
My last one was eBay as well.
Thomas Knox
> Date: Wed, 3 Apr 2013 23:15:06 -0400
> From: bobdarby at triad.rr.com
> To: time-nuts at febo.com
> Subject: Re: [time-nuts] Question about FTS 1050A
>
> Dick,
>
> If you're asking about the FTS 1050A it was on Ebay. I believe
> Symmetricom still sells them but I can't justify buying one from them.
>
> bob
>
> On 4/3/2013 10:56 PM, Richard Solomon wrote:
> > Just curious, where are you getting these from ?
> >
> > Tnx, Dick, W1KSZ
> >
> >
> > On 4/3/2013 7:21 PM, Robert Darby wrote:
> >> A little follow-up.
> >>
> >> I looked at all four 1000B outputs with the scope; one pair is at
> >> 1.2V rms and the second is at .7V rms. The waveform looks clean and
> >> is close to the 1.0V and .5V described on the spec sheet so I
> >> conclude that the oscillator is fine.
> >>
> >> I disassembled the doubler case to check the voltage there and found
> >> that the voltage regulator is working correctly. There are two
> >> identical boards inside. The oscillator feeds a Mini-Circuits AK-2(+)
> >> frequency multiplier directly and each doubled output is fed into two
> >> identical circuits each with with 4 2n2222's, two diodes, assorted
> >> resistors and caps thence out through a Mini-Circuits wideband
> >> transformer TMO4-6. With the boards on the bench I jury rigged an
> >> oscillator to drive the input and I get the same low output, albeit
> >> rather cleaner. I'm going to order some connectors so I can be
> >> certain about the signal path and check the doublers again.
> >>
> >> I wonder if someone needed four low level 10MHz outputs and
> >> ordered/modified the amplifiers to suit. I'm not sure they're
> >> working perfectly but I suspect most of the noise I'm seeing is due
> >> to my hook-up to the tnc connectors. I'll know more once I get some
> >> connectors and meanwhile I'll attempt to draw a schematic of the
> >> circuit.
> >>
> >> Thanks for everyone's comments; more later.
> >>
> >> Bob Darby
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list