[time-nuts] Getting a 5370A tomorrow - How do i test it works
cfo
xnews3 at luna.dyndns.dk
Thu Aug 29 17:06:21 UTC 2013
Hmmm ... Bad news
I started the tests in section 4 , and all went well for approx 35 min.
Test pg 4-28 - Table 4-3 - See Errata starting on page 4
PON test pg. 4-2
Step 1-13 : Disp 99.69 to 99.73 (flipping fast)
Step 14 : 100 - Disp 99.69x to 99.70x -
100 - Disp 99.68x to 99.69x -
1000 - Disp 99.689x to 99.697x -
10K - Disp 99.7061 to 99.7084 -
100K - Disp 99.7053 to 99.7096
Step 15 : Disp 13.x to 17.x (flipping) - Min 99.73/75 - Max 99.80 (Err 02)
Now the 5370A won't ARM (ARM light steady lit, with the int 10Mhz
connected to Start) ....
I goofed in one of the steps - Step 6 , where i should have selected DC
on both AC/DC switches , they were unfortunately on AC.
When i power the unit off/on it starts up fine (the start/stop) leds are
blinking , but the display shows 0.00 , and once in a while if i'm lucky
it arms and show 99.7 or so .... If i leave it .... It ends in Err02
after a while.
Any hints ?
CFO
More information about the Time-nuts_lists.febo.com
mailing list