[time-nuts] Low noise power supplies?
Max Robinson
max at maxsmusicplace.com
Fri Feb 1 19:39:14 UTC 2013
Well, I stand corrected. Weren't the TM 500 instruments marketed as low
cost?
Regards.
Max. K 4 O DS.
Email: max at maxsmusicplace.com
Transistor site http://www.funwithtransistors.net
Vacuum tube site: http://www.funwithtubes.net
Woodworking site
http://www.angelfire.com/electronic/funwithtubes/Woodworking/wwindex.html
Music site: http://www.maxsmusicplace.com
To subscribe to the fun with transistors group send an email to.
funwithtransistors-subscribe at yahoogroups.com
To subscribe to the fun with tubes group send an email to,
funwithtubes-subscribe at yahoogroups.com
To subscribe to the fun with wood group send a blank email to
funwithwood-subscribe at yahoogroups.com
----- Original Message -----
From: "David" <davidwhess at gmail.com>
To: "Discussion of precise time and frequency measurement"
<time-nuts at febo.com>
Sent: Thursday, January 31, 2013 11:10 PM
Subject: Re: [time-nuts] Low noise power supplies?
>I have seen it used in a couple of Tektronix TM500 instruments but the
> purpose may have been to generate a lower voltage power supply rail
> instead of noise reduction. Tektronix often added LC sections on
> their switching power supply outputs and distributed smaller LC
> sections to prevent coupling between different circuits.
>
> On Thu, 31 Jan 2013 22:12:42 -0600, "Max Robinson"
> <max at maxsmusicplace.com> wrote:
>
>>You haven't seen it used because it doesn't work very well. It appeared
>>in
>>a few pieces of Heathkit equipment but I don't think HP or Tek used it at
>>all. Any AC component of base to collector voltage has a small but
>>definite
>>effect on Vbe which transfers voltage in the reverse direction from
>>collector to emitter even though the base is held at AC ground. A three
>>terminal regulator does a better job of suppressing ripple from a power
>>supply.
>>
>>Regulators use a zener diode as the reference and there are circuits in
>>which a zener is used as a noise source. What does that tell you? The
>>quietest power supply is an analog regulator followed by one or more RC
>>filter sections. The inductor in an LC filter is likely to pick up more
>>hum
>>and noise than it filters out. My presumption is that a low noise power
>>supply is likely to be providing a small amount of power to the load and
>>load regulation is probably not a problem.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list