[time-nuts] "Better" gps antennas than a Symmetricom 58532A
Chris Albertson
albertson.chris at gmail.com
Tue Jan 22 04:53:25 UTC 2013
On Mon, Jan 21, 2013 at 8:23 PM, <lists at lazygranch.com> wrote:
> There was a thread on RF absorbing material a few months ago to get rid of
> reflections.. That might be a way to spend spme money. I'd like to see
> before and after results.
If you have a very good location for the antenna then RF absorbing material
is not going to help because there will be nothing to apply it to. I think
in most cases money is best spent on some 1 inch iron pipe so that anything
that is reflective is below the antenna's horizon.
So your before/after results would depend of just how poor the antenna
location has
I used a 1" pipe with a pipe flange screwed to the top end. I mounted the
antenna to the flange using four stainless steel bolts and ran the coax
cable inside the pipe. The pipe perforates the roof so the cable has a
very short and direct run.
--
Chris Albertson
Redondo Beach, California
More information about the Time-nuts_lists.febo.com
mailing list