[time-nuts] HPZ3816A config - can't enter correct co-ords

Randy D. Hunt randy_hunt960 at yahoo.com
Sat Jul 13 16:35:53 UTC 2013


On 7/12/2013 10:51 AM, Mark C. Stephens wrote:
> When I try to enter my antenna location as per surveyor:
> -33.763698
> 151.092111
>
> With this scpi command:
> :GPS:POS S,+33,+79,3.69800E+001,E,+151,+9,+2.11100E+001,+9.45600E+001
>
> For some reason, the Z3816A displays this:
> LAT      S  33:59:36.980
> LON      E 151:09:21.110
>
> Which is correct except the south should say 33:79:36.980.
>
> I can enter lower values that 59 for parameter 3 and it displays correct.
> Can't seem to find a manual for these chaps either.
>
> Shooting off the subject, Just had one arrive with a loose OCXO.
> Yes loose, the solder joint on the OCXO had broken away from the PCB.
> The intermittent contact was causing all sorts of chaos.
> Most noticeably, the red ALARM LED came on, but none of the scpi commands could tell me why.
> Health monitor reported [ OK ] <shrug>
>
> Anyway, Any idea how I can enter the correct co-ordinates?
>
>
> --marki
>
> _______________________________________________
> time-nuts mailing list --time-nuts at febo.com
> To unsubscribe, go tohttps://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
There is only 60 minutes in a degree. thus the 79 minutes in

33:79:36.980 in incorrect.

KI6WAS





More information about the Time-nuts_lists.febo.com mailing list