[time-nuts] Cheap 9.8Mhz Sa.22c's
Robert Atkinson
robert8rpi at yahoo.co.uk
Sun Jun 2 18:13:12 UTC 2013
Hi Magnus,
According to the datasheet 10MHz is a standard output. The Manual say you can change the factory setting using SSIP ( Symmetricom Serial Interface Protocol).
Unless of couse the particular units have been restricted. I don't thnik so as both the factory set frequency and 10MHz are coved by the standard unit.
Robert G8RPI.
________________________________
From: Magnus Danielson <magnus at rubidium.dyndns.org>
To: time-nuts at febo.com
Sent: Sunday, 2 June 2013, 19:06
Subject: Re: [time-nuts] Cheap 9.8Mhz Sa.22c's
On 06/02/2013 07:52 PM, Mark C. Stephens wrote:
> These are 9.8304Mhz, is possible to move them to 10Mhz?
>
> http://www.ebay.com/itm/Symmetricom-SA-22c-9-8304MHz-Precision-Rubidium-Oscillator-5V-and-15V-NICE-/261223397404
I looked at it, and no. They change the core oscillator, and then you
can alter the divide power of 2 but other than that no luck.
This limits their uses outside the intended usage.
Cheers,
Magnus
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list