[time-nuts] Connector For Trimble/Nortel GPSTM (NTGS50AA) ?
EB4APL
eb4apl at cembreros.jazztel.es
Mon Jun 3 17:12:33 UTC 2013
Hi,
I also connected it directly, the weird 110 pin connector probably costs
more than I paid for the NTGS50AA. If in the future I want to use any
signal present in the connector it can be done using small individual
pins. Now the question, has somebody successfully used the internal
serial port (the one that goes to CM, the cell tower equipment)? It
could be a weird mean of turning the yellow "Comm fault" led off and the
green "In service" one if conveniently used with a PIC or equivalent
microcontroler. According to the available documentation they speak SCPI
(the same as used in the GPIB, I think) over an EIA-485 physical layer,
but no mention is made of the commands used, the only thing that is
clear is that indicates no communications with the CM in the last 60
seconds. Just sending anything that triggers a response could be enough.
Regards,
Ignacio EB4APL
On 03/06/2013 18:42, Bob Camp wrote:
> Hi
>
> That's what I have done. Cheaper and (hopefully) more reliable than a
> connector.
>
> Bob
>
> -----Original Message-----
> From: time-nuts-bounces at febo.com [mailto:time-nuts-bounces at febo.com] On
> Behalf Of Frederick Bray
> Sent: Monday, June 03, 2013 10:57 AM
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] Connector For Trimble/Nortel GPSTM (NTGS50AA) ?
>
> So, I gather that most folks are just connecting power to the
> appropriate 2 pins on the 110 position connector. I wasn't sure whether
> people were wiring directly to the DC converter.
>
> Thanks.
>
> Fred
>
>
> On 6/3/2013 3:53 AM, Erno Peres wrote:
>> there is only a 48Volt connection and some unknown data com.... I did not
> use any mating connector just the power in... everything is available on the
> front plate.
>
More information about the Time-nuts_lists.febo.com
mailing list