[time-nuts] Repair of PRS10 Lamp Assembly
Herbert Poetzl
herbert at 13thfloor.at
Mon Mar 18 04:14:26 UTC 2013
On Sun, Mar 17, 2013 at 08:24:37PM -0400, Brucekareen at aol.com wrote:
> I am afraid the PRS-10 lamp starting algorithm is a little involved.
> I believe that once the lamp temperature is in the starting
> range, the microprocessor ramps up the drain and possibly gate
> voltage of the heating oscillator FET until the bulb strikes
> as evidenced by a DC signal at the detector.
> If the lamp overheats (as measured by thermistors imbedded in
> the back of the lamp block), at some point the microprocessor
> will reduce the drain voltage to a safe steady-state value.
> The starting constants for each individual PRS-10 are
> factory-set in the unit's programmed software, and as far as
> I know, access to change these settings has not been made
> available yet to end users.
Assuming that this is the correct image for an PRS-10
(http://goo.gl/Q4ztp), the CPU used looks like an
MC68HC711E20CFN3 (http://goo.gl/Zhxzv) which would mean
that it should be simple to reverse engineer the program
and data stored there ....
> This makes it difficult to swap lamps between units.
> I have a PRS-10 with a lamp that is just on the edge
> of starting properly. Since I cannot change the factory-
> programmed values, I have tried adding a shunt resistor to
> increase the lamp current to the point where it would reliably
> start. But, unfortunately, other problems seem to be keeping
> the unit from working properly.
> The only luck I have had in repairing a non-working PRS-10
> with certainty, was one in a Symmetricom 2500 Time Source
> that turned out to have a failed Mini-Circuits VCO on the
> synthesizer board. Replacing the VCO module restored proper
> operation.
> Perhaps someday the factory will provide end users with access
> to what are now "factory-only" settings.
If there is really an interest in this, just send me
one or maybe two units and I'll give it a try, no promises
though, but I've done a lot of work with motorola CPUs
in the past ...
best,
Herbert
> Bruce, KG6OJI
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list