[time-nuts] SR620: cal error 23

[Herbert Poetzl]

On Mon, Mar 18, 2013 at 04:28:32PM +0100, Volker Esper wrote:

> Hi all,

> While auto calibrating the SR620 I get the message "cal error  
> 23" - the manual isn't that specific about this message, it    
> only states, that error numbers 19 to 23 are caused by Stop    
> TAC problems. 

The manual also states that error codes 19-23 are the
same as the start values (n - 16), so 23 minus 16 should
be the same as '7' i.e. 'stop linearity byte out of range'

> However, the counter counts, but I can't do automatic
> calibration any more.

> Anyone having experience with that?

Sorry, no further experience with that

HTH,
Herbert

> Thanks a lot
> Volker

> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.