[time-nuts] Z3801A, Z3805A Pforth interpreter.

Tom Van Baak tvb at LeapSecond.com
Sat May 18 14:11:26 UTC 2013


> So typing watch exits the interpreter, but it also appears to reboot so don't mess with your master clock now...

Mark,

Use halt rather than watch to exit pForth mode; that's how I alternate between SCPI and p4th on a running system. See also: http://leapsecond.com/museum/z3801a/eeprom.htm

- I use pr_gps_id to get the VP version numbers rather than tap the Oncore Rx/Tx pins.
- I send hourly queries for pll_rep, efc_rep to dump the circular EFC regression table.
- The following give a little more info than the SCPI syst:stat? command:
  print_stat, pr_gps_istate, pr_time_raim, pr_gps_debug, print_vis
- Note that pr_efc gives 32x higher resolution than SCPI diag:rosc:efc:abs? command. That is, it shows you the fraction that goes into the DAC dither calculation. You can set the DAC too. See also: http://leapsecond.com/pages/z3801a-efc/

/tvb





More information about the Time-nuts_lists.febo.com mailing list