[time-nuts] Pendulum CNT91 with TimeLab
GandalfG8 at aol.com
GandalfG8 at aol.com
Wed Oct 9 19:31:35 UTC 2013
Has anybody had any success setting up the Pendulum CNT91, or the
Tektronix rebadged equivalent FCA3100, to run with TimeLab?
It was suggested here some time ago that it should be possible to achieve
this by running the counter in talk only mode but so far I've had no luck
with the FCA3100 and am aware of similar problems with the CNT91.
I suspect this is more likely a counter issue, or perhaps in my case that
should read "user issue":-) rather than anything to do with the software.
I'm using an NI USB GPIB adapter and can run the FCA3100 with the cut down
Tektronix supplied version of NI's Signal Express, but whilst I can also
talk to it using NI's Measurement and Automation Explorer any attempts with
that to switch it into talk only mode either don't work or perhaps it's
reverting as soon as I close the software to switch over to TimeLab.
I've also tried running the counter in GPIB "compatible" mode", where it's
claimed to emulate the SCPI command set of the HP 5313x series, but as far
as I can tell TimeLab is rejecting the data because it checks for a valid
HP ID string whilst the counters still respond as either an FCA3100 or
CNT91.
Regards
Nigel
GM8PZR
More information about the Time-nuts_lists.febo.com
mailing list