[time-nuts] Surface Mount OCXO Questions
Graham / KE9H
timenut at austin.rr.com
Wed Oct 30 13:54:05 UTC 2013
John:
All SMT OCXO's will either have a recommended PCB footprint in the spec
sheet
or will refer you to a recommended footprint in another document.
Some don't care about a ground plane under the part, some require it
with no crossing signals, some require an open thermal hole underneath
the oven. I have seen all three cases. As usual, it is suggested that you
read the [] manual.
Best regards,
--- Graham / KE9H
==
On 10/29/2013 9:18 PM, John C. Westmoreland, P.E. wrote:
> Hello,
>
> I was wondering if I could get some recommendations on surface mount OCXO's
> vs. the traditional through hole.
>
> I was also wondering on the board layout - if you found it necessary to
> leave a thermal moat so to speak - and what worked best. Maybe the OCXO
> has an internal air barrier that maybe would make this unnecessary - not
> sure.
>
> Your input and experience appreciated.
>
> Thanks,
> John Westmoreland
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list