[time-nuts] My FE-5680A Came In Today
Bob Camp
lists at rtty.us
Wed Sep 18 00:14:58 UTC 2013
Hi
The PPS is fed by a (weak) gate that has a goofy supply arrangement. It will drive a CMOS load, but not a lot else. On some units it only comes on once the Rb locks up.
Bob
On Sep 17, 2013, at 7:00 PM, Bob Stewart <bob at evoria.net> wrote:
> Hi Nigel,
>
> All I know is what's on the ebay listing. It's number 270851051022. There is a tiny RF connector on the top board of the 3 that are stacked inside the package that correlates with other modded boards I've seen online. It looks like people generally tap into that. Mine is supposed to have a 1PPS signal on pin-6, which I do not see. Also, there is a flashing LED inside that is not synced to 1PPS. I dunno whether that means it's not synced up yet, or that it is. Funny that it's just blinking, and not a 1PPS heartbeat.
>
> Bob
>
>
>
>
>> ________________________________
>> From: "GandalfG8 at aol.com" <GandalfG8 at aol.com>
>> To: bob at evoria.net
>> Sent: Tuesday, September 17, 2013 5:46 PM
>> Subject: Re: [time-nuts] My FE-5680A Came In Today
>>
>>
>>
>> Hi Bob
>>
>> Do you know what version of the FE5680A you've bought, and where are
> you measuring the frequency?
>>
>> Regards
>>
>> Nigel
>> GM8PZR
>>
>> In a message dated 17/09/2013 23:22:03 GMT Daylight Time, bob at evoria.net
> writes:
>> My FE-5680A Rb standard came in today. After the usual inspections etc, I fired it up and I have the purple haze. The native output is 8.38860798/9 (last digit jitter) as read on my 5335A using my GPSDO as an external standard. I've got a ways to go before it's all setup, but this is looking good. Does it warmup and change frequency at all, or can I retune it to 10MHz and use it as a reference without any further ado?
>>>
>>> Can someone tell me what type of socket that is where you tap off
> the RF? It looks sort of like a uFL connector, but a bit bigger.
> I'd rather avoid hacking and soldering on this if I can.
>>>
>>> Bob -
> AE6RV
>>> _______________________________________________
>>> time-nuts mailing
> list -- time-nuts at febo.com
>>> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>> and follow the
> instructions there.
>>
>>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list