[time-nuts] GPSDO vs Rb standard
Bob Stewart
bob at evoria.net
Fri Sep 20 23:35:45 UTC 2013
Understood. If I do anything, it will probably be to cut pins 8 and 9 at the board side of the connector and route the serial connections there. I dislike opening this thing up any more often than I have to. Thanks for all the info.
Bob
>________________________________
> From: Bob Camp <lists at rtty.us>
>To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
>Sent: Friday, September 20, 2013 5:34 PM
>Subject: Re: [time-nuts] GPSDO vs Rb standard
>
>
>Hi
>
>All of my FE Rb's have serial out of a 9 pin D connector. They bring power (+15 and +5) in on that connector, and put 1 pps and 10 MHz out on the same 9 pin D.
>
>There are (apparently) dozens of variations of the FE 5680. There is no single standard for what is hooked up where. I'd be *very* careful about playing with wires I had not either traced out or had data from the seller on. It's *very* easy to blow one of these beasts up.
>
>On mine serial is normal RS-232 levels on pins 8(rx) and 9(tx). 15 V power is on pin 1, ground on pins 2 and 5, +5 power is on pin 4.
>
>Outputs are on 6 (pps), 7 (10 Mhz), 3 (lock).
>
>Again - I'd be *very* careful with information that may or may not apply to your specific Rb.
>
>Bob
>
>
>On Sep 20, 2013, at 5:25 PM, Bob Stewart <bob at evoria.net> wrote:
>
>> Bob,
>>
>>
>> Does your Rb send the serial out on the DB-9, or did you solder in a connection? I'm looking at mine and it looks like pin 8 is connected to something and pin 9 seems to come in to an empty SMT slot for a cap or resistor. I was thinking of bringing a ribbon cable out between the covers above the DB-9, but maybe I should just take over 2 pins on the DB-9? Any ideas what the pins 8 and 9 would have been hooked up to if they don't go to the serial input?
>>
>>
>> Bob
>>
>>
>>
>>
>>> ________________________________
>>> From: Bob Camp <lists at rtty.us>
>>> To: Discussion of precise time and frequency measurement <time-nuts at febo.com>
>>> Sent: Wednesday, September 18, 2013 7:25 PM
>>> Subject: Re: [time-nuts] GPSDO vs Rb standard
>>>
>>>
>>> Hi
>>>
>>> When I want to tune an Rb, I just hook up to it with a terminal program and hack away at it. There's not a lot to the protocol.
>>>
>>> Bob
>>>
>>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com
>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
>
>
>
More information about the Time-nuts_lists.febo.com
mailing list