[time-nuts] quartz clock/watch question
Bob Camp
lists at rtty.us
Fri Apr 18 23:41:02 UTC 2014
Hi
We used to do it with a microphone. Nothing fancy, just a simple little guy with the inductance resonated out at 32 KHz. The output feed a computing counter. It worked fine as long as the microphone was in contact with the watch or watch module.
Bob
On Apr 18, 2014, at 7:25 PM, Bob Albert <bob91343 at yahoo.com> wrote:
> I have tried to pick up the oscillator from my wristwatch and have been unsuccessful.
>
>
> I tried both magnetic and electric probes. Nothing.
>
> Bob
>
> On Friday, April 18, 2014 4:12 PM, Tom Van Baak <tvb at LeapSecond.com> wrote:
>
>> When a quartz watch or clock is assembled, what method is used to get it as accurate as possible?
>
> Bob,
>
> First generation quartz watches had a tiny F/S (fast/slow) trimmer capacitor. These days it's done with skip cycles and one-time factory calibration. Think leap days or leap seconds -- it's easier and more reliable than changing the frequency of the oscillator itself. It's also one less part, easier to calibrate, and unlike active and passive components, math has no environmental sensitivity.
>
> Have a quick read of 32 kHz watch IC's like:
> http://www.nxp.com/documents/data_sheet/PCA2000_2001.pdf
>
> /tvb
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list