[time-nuts] Tektronix TM500 extender cable kit
Dave Daniel
kc0wjn at gmail.com
Mon Aug 4 15:02:32 UTC 2014
Several people on the TekScopes/Tekscopes2 forums went through this a
while back. It turned out that ribbon cable appropriate for this
application was either not available or too expensive.
John Griessen made a set of PWBs and sold kits consisting of a PWB pair,
a connector pair and a set of pre-cut and pre-stripped wires. I believe
he sold all the kits.
I built one of mine and it works well. I use it with a TM-501 as a
stand-alone test setup for single-wide plug-ins.
DaveD
On 8/3/2014 11:54 PM, Mark Sims wrote:
> I think a cable made from ribbon cable edge connectors would be the easiest/cheapest way to extend the GPIB connector.
> ------------------------
>> Have you thought about making extensions for the smaller connector used to distribute GPIB in the 5000 series?
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list