[time-nuts] Tektronix TM500 extender cable kit

Tom Miller tmiller11147 at verizon.net
Tue Aug 5 00:35:14 UTC 2014


Except for the three wide units such as the CG5011, CG551, etc.

Tom

----- Original Message ----- 
From: "R.Phillips" <phill.r1 at btinternet.com>
To: "Discussion of precise time and frequency measurement" 
<time-nuts at febo.com>
Sent: Monday, August 04, 2014 12:11 PM
Subject: Re: [time-nuts] Tektronix TM500 extender cable kit


> Am I right in thinking that two of these connector/cables would give the 
> full facilities on the 5000 series units.
> Roy
>
>
> -----Original Message----- 
> From: Dave Daniel
> Sent: Monday, August 04, 2014 4:02 PM
> To: Discussion of precise time and frequency measurement
> Subject: Re: [time-nuts] Tektronix TM500 extender cable kit
>
> Several people on the TekScopes/Tekscopes2 forums went through this a
> while back. It turned out that ribbon cable appropriate for this
> application was either not available or too expensive.
>
> John Griessen made a set of PWBs and sold kits consisting of a PWB pair,
> a connector pair and a set of pre-cut and pre-stripped wires. I believe
> he sold all the kits.
>
> I built one of mine and it works well. I use it with a TM-501 as a
> stand-alone test setup for single-wide plug-ins.
>
> DaveD
>
> On 8/3/2014 11:54 PM, Mark Sims wrote:
>> I think a cable made from ribbon cable edge connectors would be the 
>> easiest/cheapest way to extend the GPIB connector.
>> ------------------------
>>> Have you thought about making extensions for the smaller connector used 
>>> to distribute GPIB in the 5000 series?
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to 
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there. 




More information about the Time-nuts_lists.febo.com mailing list