[time-nuts] Lucent KS-24361 10 Mhz out success.
Anthony Roby
aroby at antamy.com
Thu Dec 4 01:24:42 UTC 2014
Paul - could you elaborate on where you made the connections? A few photos perhaps?
Nice work,
Anthony
-----Original Message-----
> On Dec 3, 2014, at 6:04 PM, paul swed <paulswedb at gmail.com> wrote:
>
> Have successfully tapped into the clean 10 MHz of the the Lucent and
> using a EL2020 50 Mhz current opamp have a very nice 10 Mhz sine wave
> out. Any spurs are down at least 43 db. Close in at 4Khz total span or
> 500 Hz/div I don't see anything down to at least 65 db. Thats the best
> detail the HP 8568B will allow.
>
> To get the signal out of the Lucent I sliced the 15 Mhz trace and
> injected the 10 Mhz into the SMA output connector.
>
> I am sure there are many other amplifiers and methods that could be
> used but this ones working well and can drive some real coax lengths.
>
> Now the really hard part. Mounting it and the power supply into a rack
> panel.
> Regards
> Paul
> WB8TSL
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list