[time-nuts] Linear voltage regulator hints...
bob at evoria.net
Tue Dec 9 18:48:53 EST 2014
I just wanted to clarify this, so that credit goes where it's due. Dan is helping me with my GPSDO project, and he was the one who came up with the idea of putting the 125 gate on with a good power source. Left to myself, I'd still be trying to figure out how to cancel the thermal noise.
From: ed breya <eb at telight.com>
To: time-nuts at febo.com
Sent: Tuesday, December 9, 2014 3:30 PM
Subject: Re: [time-nuts] Linear voltage regulator hints...
I'd recommend going with what Bob Stewart mentioned, using separate
gates as buffers, operated from a better-grade reference, to shift
from the noisier and driftier logic supplies, into the more critical
circuits. It's simple, and can be powered from a modest reference circuit.
If the logic circuits themselves need better supply noise and tempco
performance, don't use any kind of three-terminal regulators - use a
good opamp driving a pass transistor. Use a reference IC that has a
buried zener for lowest noise - this eliminates all the low voltage
references and three-terminal etc regulators that use band-gap
references. The down side is that the good kind of reference ICs will
need a higher (like 10V and up) operating voltage than may be
available, so that complicates it.
For a system using a conventional PC-style supply, with +5V and +12V
available, an LM399, for example, could run from the +12V, along with
the opamp circuitry, while the pass transistor could feed from the
+5V, dropping to the +3.3V or whatever low logic supply is needed.
For modest current requirement, use only an NPN pass transistor in
emitter-follower mode. For higher currents, add another NPN
emitter-follower in front of it for more drive - its collector can be
supplied from the +12V via some limiting R, to ensure enough
overhead. The opamp and associated network resistors, of course,
should have performance commensurate with the reference, and
sufficient for the application. Since there's also plenty of digital
and PS noise around, a lot of bypassing in the right spots should help a lot.
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts