[time-nuts] Lady Heather and comm port setup...
Chuck Harris
cfharris at erols.com
Wed Dec 17 05:59:08 UTC 2014
Thanks Mark!
I figured that there had to be a way, especially given that
Trimble's former TSIP standard was 9600,8,ODD,1.
Now, if I could figure out why LH thinks it needs something
newer than windows 95... which is what is on the old 486
laptop that I would like to use for that purpose...
-Chuck Harris
Mark Sims wrote:
> Since version 3.1 Lady Heather should be able to find a 9600,8,ODD,1 device. This
> was added for the Resolution T timing receiver. It may take it a minute or so
> for it to figure out. If the program does not see a valid receiver version
> message within 30 seconds or so it toggles the parity setting and tries again.
>
> Or you can try the /rt command line option. This says to try ODD parity first.
> _______________________________________________ time-nuts mailing list --
> time-nuts at febo.com To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the
> instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list