[time-nuts] Lady Heather command question

Azelio Boriani azelio.boriani at screen.it
Fri Feb 7 21:21:02 UTC 2014


These commands are entered while LH is up and running, not on the
command line. See this old (September 2011) message
http://www.febo.com/pipermail/time-nuts/2011-September/059113.html for
example.

On Fri, Feb 7, 2014 at 5:52 AM, Michael Baker <mpb45 at clanbaker.org> wrote:
> Thank you Azelio, for your response to my question
> regarding how to get Lady Heather to display the
> signal-strengths vs AZ and EL.
>
> I have been trying to figure out how to get LH to display
> the signal strength diagram. I have been entering
> 'SAS' <ret> into the command line. LH responds by
> clearing off the ADEV lists but then starts the ADEV lists
> all over again.
>
> Where do the SAS, SAD, SAE, SAA, SAW, SAC commands
> and their function explanation appear?
> I do not see them listed anywhere.
>
> What is the correct procedure for entering the commands?
>
> Are you saying I should enter ' SAS/SAD/SAE/SAA ' (ret)...?
>
> In other words, enter all the commands in sequence separated
> by the forward slash (/)...?
>
> Thanks--
>
> Mike Baker
> **********************************
>
>
> Azelio Boriani said:
> Use:
> S A S signal
> S A D data
> S A E elevation
> S A A azimuth
> S A W
> S A C to clear the view
>
> --
>  "The duty of a Patriot is to protect his
> country from its government." - Thomas Paine
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.



More information about the Time-nuts_lists.febo.com mailing list