[time-nuts] WTB WECO Adapter

W4wj at aol.com W4wj at aol.com
Thu Jul 10 18:54:23 EDT 2014


TNX for that information Chuck!!
 
73
Don
W4WJ
 
 
 
In a message dated 7/10/2014 5:29:28 P.M. Central Daylight Time,  
cfharris at erols.com writes:

Be  warned, that Trompeter makes at least two varieties.
The one you want has  the thicker center pin that extends
to within 1/8 inch of the end of the  shield.  The incorrect
connector has a thinner center pin that only  extends to
about 1/4 inch of the end of the shield.

The family  number of both the right and the wrong connector
is the same:  TEI-14949

The part that specifies the pin is AD1 for the wrong  connector,
and AD1W for the right connector...

So the full part  number of the connector you desire is:

TEI-1949 AD1W

These are  Western Electric (eg. telco) connectors, not the
more common video patch  panel connectors.

-Chuck Harris

OBTW, if you have any of the  cable mounted WECO connectors,
it is very easy to screw a standard chassis  mount BNC connector
where the cable screws in, and make your own  adapter.

W4wj at aol.com wrote:
> Stan...
>
> I'll check  Trompeter too...
>
> TNX
>
>
> 73
>  Don
> W4WJ
>
>
>
> In a message dated 7/10/2014  12:35:45 P.M. Central Daylight Time,
> stanw1le at verizon.net  writes:
>
> Consider  the Trompeter series of adapters.   Stan,  W1LE
_______________________________________________
time-nuts mailing  list -- time-nuts at febo.com
To unsubscribe, go to  
https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the  instructions there.




More information about the time-nuts mailing list