[time-nuts] Synergy-GPS SSR-6tru problems

[Rex]

I think your story is rather incomplete. You never (to my deduction) 
told us what you are plugging this into. You mention a GPSDO so I guess 
that is where it is plugged while not doing what you want, but you never 
mention what that GPSDO might be.

You blew off Art Sepin's reply as not relevant. Why? What is the 
communication path to the receiver from whatever you are using to send 
commands? Is it through the GPSDO? If so, it seems to me the 
communication may not be direct and may be filtered by the GPSDO so the 
commands you are sending aren't reaching the new board in the way you 
would like.

I never used one of these new boards you are trying to use, but if you 
want good answers I think you need to tell us exactly what you are 
plugging it into and through what signal path you are issuing the commands.



On 7/15/2014 2:36 PM, Bob Stewart wrote:
> I got one of these recently, along with the adapter board.  This is the ublox only version, and I am using u-center version 8.11 software.  I am unable to make it work properly.  The NMEA section happily sends out messages, but I cannot get anything else to work.  e.g. it ignores the commands to turn off antenna power.  It ignores the command to put it in Survey-In mode.  Nothing is displayed when monitoring the SVIN field.  I sent the board back and received one that they have tested there at the site.  Same story.  When I plug my UT+ into the same connector in my GSPDO, it works just fine and responds properly to commands from WinOncore12.  I have used both a serial port adapter and a USB-adapter to drive the TTL lines to the board.
>
>
> So, there is something wrong at my end, and it's probably something so trivial that no-one would think to mention it.  Has anyone tried this board?  Can you think of any setting that's "inherently obvious to the most casual observer" that a newbie could repeatedly overlook?  For example, is there some first setting that you always do in u-center to shut down the NMEA and turn on the UBX, but the setting does not save on the board and the u-center software always overrides it?
>
>
> The configuration is this:  The adapter does the 3V to 5V stuff, and plugs into the same connector as my UT+.  The antenna lead is connected to a non-powered port on my GPS Source splitter.  The splitter connects to a puck in the attic via RG-6.  The SNR of the received signals is in the 20-50 range on the u-center display window.  I have tried driving a different puck directly that is in my lab room.  No change except for lower SNR values.
>
>
> Bob - AE6RV
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>