[time-nuts] Synergy-GPS SSR-6tru problems

[Bob Stewart]

Hi Paul,

No, it's the right configuration.  The part number is as you say and it says SSR-6tru on a paper label.  I'm certain it's something on my end, but I just don't see it.  I think I'm going to go the mini-clips route, assuming a USB adapter will power the board.  I'll have to look at the specs to see current draw.


Bob



________________________________
 From: Paul <tic-toc at bodosom.net>
To: Discussion of precise time and frequency measurement <time-nuts at febo.com> 
Sent: Wednesday, July 16, 2014 2:33 PM
Subject: Re: [time-nuts] Synergy-GPS SSR-6tru problems
 

On Wed, Jul 16, 2014 at 2:54 PM, Bob Stewart <bob at evoria.net> wrote:
> I fooled around with PUBX 41, and can't get the board to respond.

I had some problems but that's because they sent the wrong
configuration (a 16062133G).  What's the part number? Assuming it
hasn't changed a TRu is 16062152G.

> I don't have the ability to deal with those .05" spaced pins on the GPS
> board's connector, or to supply the 3V power.

I was able to compress and heat shrink some .1 connectors on a .05
connector although I didn't try it on the SSR-6T.

--
Paul
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.