[time-nuts] 3.0GHz Channel 3 installation in Agilent 53132A counter
Brian Inglis
Brian.Inglis at SystematicSw.ab.ca
Tue Mar 18 19:32:17 UTC 2014
On 2014-03-18 12:19, James Robbins wrote:
> I hope this is not too OT.
> I have acquired a 3.0GHz original Channel 3 board for my Agilent 53132A
> counter. When installed, it reads four times (4x) the actual frequency.
> I'm wondering if anyone has any experience with such an installation and can
> point me to some setup item or zero ohm resistor I'm supposed to install.
> All that the manual says is to have it done by the factory. That will cost
> me more than the board itself. Many thanks.
> Jim Robbins
> N1JR
According to:
http://cp.literature.agilent.com/litweb/pdf/53132A-04A.pdf
early serial numbers may need updated firmware.
--
Take care. Thanks, Brian Inglis
More information about the Time-nuts_lists.febo.com
mailing list