[time-nuts] 2.5V reference IC in HP E1938 oscillator.
Richard (Rick) Karlquist
richard at karlquist.com
Sun Nov 9 22:53:15 UTC 2014
Hi, I was the designer of the board, but I don't remember the
part number of the reference. I will try to consult my paper
schematic when I get a chance, if no one else can help you.
I do remember that I originally used some convenient reference
which seemed OK from the data sheet, but turned out to be
too noisy. I changed it to a different one.
When asking questions such as this, it is helpful to know why
you need to know the part number.
Rick Karlquist N6RK
On 11/9/2014 12:54 PM, Rob040 . wrote:
> Dear time-nuts,
> Can anyone enlighten me by telling which IC has been used for creating the +2.5V reference voltage on the oscillator board of the E1938?It's the only IC in the diagram where the type number is not mentioned. In a post of years back I found LT1121, but that one is a voltage regulator and is used on the control board.
> Cheers!
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
>
More information about the Time-nuts_lists.febo.com
mailing list