[time-nuts] 10MHz LTE-Lite

[paul swed]

Said
Thanks missed that.
Regards
Paul

On Thu, Nov 20, 2014 at 6:17 PM, S. Jackson via time-nuts <
time-nuts at febo.com> wrote:

> Paul,
>
> if you set the serial switch on the LTE-Lite over to the NMEA side then the
>  uBlox application will give you all sorts of bar graphs for signal
> strengths,  position, time, etc as it decodes all the NMEA messages.
>
> Alex,
>
> the TSC5125A user manual contains a description of the theory in its
> Appendix B. Its probably available on the Microsemi website as I don't
> think its
> confidential.
>
> Also, I think John's TimePod user manual probably has a description of it.
> Otherwise I remember Sam Stein (who is behind the TSC units) had some PTTI
> or  similar presentations discussing the technology, but I don't know where
> those  could be downloaded.
>
> Bye,
> Said
>
>
> In a message dated 11/20/2014 14:34:32 Pacific Standard Time,
> alex at pcscons.com writes:
>
>
>
> Hi Said,
> do you have any information about how that  "TimePod 5330A works" any
> principal  description?
> 73
> KJ6UHN
> Alex
>
> On 11/20/2014 2:08 PM, S. Jackson  via time-nuts wrote:
> > Hello Mike,
> >
> > attached  is a 10MHz DIP-14 TCXO Phase Noise plot from a random  LTE-Lite
> >  unit.
> >
> > I had sent out a 20MHz typical phase noise  plot some weeks ago, and
> > comparing the two they are almost perfectly  6dB apart as would be
> expected from
> > the 20log(n/m) relationship. There  are variations from unit to unit of
> > course,  but it does not seem  like one version of the board or the other
> has
> > advantages  in  terms of phase noise.
> >
> > I had also sent out a  superimposed plot of the 20MHz and the divide-by-2
> > 10MHz output of the  same board at that time, and again the relationship
> was
> > almost  perfectly 6dB lower at 10MHz versus 20MHz.
> >
> > While  phase noise follows theory, it does seem that the DIP14 metal
> shield
> >  has a beneficial effect on the ADEV stability though. The plots we are
> >  getting  are pretty darn good, and I want to test more boards before I
> post any
> > ADEV,  because its quite a bit better than our  specification and I want
> to
> > make sure  its  real.
> >
> > The 10MHz DIP-14 boards do not have an  isolating buffer like the 20MHz
> > boards do, on these the TCXO drives  the output directly, so one must be
> careful
> >   to set the  equipment to 1M Ohms input impedance or use a buffer
> > externally,   which is what we did to measure the attached PN plot.
> >
> > Bye,
> > Said
> >
> >
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>