[time-nuts] Missing "scpi> " prompt on KS-24361

[Hal Murray]

I had things setup so one J6 went to ntpd and the other went to a hack that 
logged some data and displayed an occasional status screen.

Then I had a power failure.

One side came back OK.  The other was sending some junk every second and 
ignoring what I sent to it.

I found an old message that covered part of the problem.
  https://www.febo.com/pipermail/time-nuts/2014-November/088446.html

I can now talk to it and it does what I expect.  Except that I don't get any 
"scpi> " prompt to tell me when it is ready.  I tried resetting to factory 
defaults.  Is there another command that I'm missing?



-- 
These are my opinions.  I hate spam.