[time-nuts] Ublox LEA-6T CFG-PRT command question
Attila Kinali
attila at kinali.ch
Fri Jul 17 14:34:27 UTC 2015
On Thu, 16 Jul 2015 23:07:49 +0000 (UTC)
Bob Stewart <bob at evoria.net> wrote:
> I want to change the UART1 port speed on my LEA-6T via message string from my
> GPSDO board. I had assumed that I would have to discover (or know) the baud
> rate already set on the LEA-6T in order to change it. But it appears that
> the LEA-6T can receive messages at any baud rate, but you need to send baud
> rate change commands at the baud rate you wish to change it to. Can anyone
> verify if this is the case? I can't find anything in the documentation I
> have that addresses this question. Maybe it's just obvious to everyone else?
Have you tried to send that question to the u-blox support?
They would be the right ones to answer it (and properly document it).
If you don't get an anwswer within a reasonable time (let's say a week or two)
please let me know.
Attila Kinali
--
It is upon moral qualities that a society is ultimately founded. All
the prosperity and technological sophistication in the world is of no
use without that foundation.
-- Miss Matheson, The Diamond Age, Neil Stephenson
More information about the Time-nuts_lists.febo.com
mailing list