[time-nuts] 10MHz Square to Sine Wave Conversion
Bob Camp
kb8tq at n1k.org
Fri Jul 17 17:26:50 UTC 2015
Hi
If you attach a filter with a shunt capacitor (capacitor to ground) at it’s input to the output of a logic gate,
that gate will pull far more current than it would without a shunt capacitor being present. You can try to
minimize this with a series resistor, but that’s only a partial fix.
Bob
> On Jul 17, 2015, at 5:49 AM, timeok at timeok.it wrote:
>
>
>
> It is the simplest solution because you have not to tune the notch filter but you have -20dB on 2nd harmonic and -40dB for the third instead -50dB (min for both) if you made a low-pass with notch filters.
>
> Luciano
>
>
>
>
> On Fri 17/07/15 05:10 , D W <watsondaniel3 at gmail.com> wrote:
>
>> Hi,
>>
>> A while back I ordered an item of equipment from a very excellent eBay
>> seller, johnkw40. He may be a member of the list, I'm not sure. He included
>> a schematic for a low pass filter circuit to filter a 10 MHz square wave to
>> a sine wave.
>>
>> A quick analysis shows that it is a 5th order chebyshev filter with a
>> cutoff frequency of about 14MHz. You could do better, but this filter can
>> be built with only five standard value passives, which is quite convenient.
>>
>> I made a little SMT version of it and ordered the boards on OshPark. It
>> seems to work pretty well. The circuit schematic and a screen shot of the
>> response is attached. Any comments from the list on how that looks would be
>> welcome.
>>
>> Dan
>>
>>> On Jul 16, 2015, at 10:49 AM, skipp Isaham via time-nuts wrote:
>>>
>>> re: 10MHz Square to Sine Wave Conversion
>>>
>>> The GPSDO I recently acquired outputs a 10 MHz square wave. I'd like
>>> to convert it to a sine wave and I am looking for suggestions and info
>> re
>>> any reasonable pre-made circuits and/or boards. No sense reinventing the
>>> wheel if I can avoid it.
>>>
>>> Otherwise I will start Sent from my iPhone
>>>
>>> Thank you in advance for your replies.
>>>
>>> Regards,
>>>
>>> skipp
>>>
>>> skipp025 at yahoo dot com
>>>
>>> _______________________________________________
>>> time-nuts mailing list -- time-nuts at febo.com
>>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts [1]
>>> and follow the instructions there.
>>
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts [2]
>> and follow the instructions there.
>>
>>
>>
>> Links:
>> ------
>> [1]
>> http://webmail.timeok.it/parse.php?redirect=https://www.febo.com/cgi-bin/ma
>> ilman/listinfo/time-nuts[2]
>> http://webmail.timeok.it/parse.php?redirect=https://www.febo.com/cgi-bin/ma
>> ilman/listinfo/time-nuts
>>
> Message sent via Atmail Open - http://atmail.org/
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list