[time-nuts] Square to sine wave symmetrical conversion (part 2)

timeok at timeok.it timeok at timeok.it
Sat Jul 25 08:34:35 UTC 2015



> bypassing the inverter you will improve phase noise. Yuo will probably
> need a sine buffer at 10MHz to drive 50 ohms.

This separator con be the solution:  http://www.timeok.it/files/hp5065AoptH10v200.pdf
high input impedance, output 50Ohm, high power handling and low additive phase noise.

But before measure using an oscilloscope the output of the GPS OCXO directly on the output pin to verify if there is a sine-wave or square 

Luciano
timeok
Message sent via Atmail Open - http://atmail.org/



More information about the Time-nuts_lists.febo.com mailing list