[time-nuts] Symmetricom(R) TS2100-GPS update and conversion
Gerhard Wittreich
gerhard at wittreich.org
Thu Jul 30 12:17:55 UTC 2015
Greg,
I did both those upgrades a few weeks ago and have been very pleased with
the results. Desoldering the TCXO is a bit tricky and takes some
patience. I do not have the "widget board" in my TS-2100 so I'm not much
help there.
I assume you already have your OCXO...The correct one is a bit hard to find.
Gerhard R Wittreich, P.E.
N3PL
On Wed, Jul 29, 2015 at 11:08 PM, Gregory Beat <w9gb at icloud.com> wrote:
> The TymServe TS2100 arrived this afternoon. So I started with the GPS
> receiver swap (update).
>
> I removed the Trimble ACE III receiver (39818-C), but noted that this
> specific unit had a "widget board" (65398.69) on the SMA antenna connector
> and 2 wires (DC power) to the 3-pin header on the main board.
>
> Was this board used to support +12 VDC powered outdoor antennas?
> ----
> Installed the Heol N024-TS-V2.1 receiver (ACE III clone w/corrections) and
> connected a Trimble 28367-00 GPS antenna (small mag mount) to the
> receiver's antenna port.
>
> From a dead cold start, in urban canyons, I had tracking in about a minute
> and lock in about 20 minutes. So far, so good. Next will be the TCXO to
> OCXO conversion (MTI 240-0530-D).
>
> greg
> w9gb
>
> Sent from iPad Air
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>
More information about the Time-nuts_lists.febo.com
mailing list