[time-nuts] Trimble Thunderbolt question, splitting its output.

[d0ct0r]

In my project, I was using LT6957 to share 10Mhz from my TBolt. It was 
perfectly fine for my setup. I split 10Mhz to feed the clock of MCU and 
second output was connected to DDS block (AD 9852).

Regards,
Vlad

On , Chris Wilson wrote:
> 27/03/2015 17:14
> 
> My T/Thunderbolt has operated flawlessly for some years feeding a
> David Partridge frequency divider board. The board gives 10Mhz and
> lower divisions of 10MHz down to the KHz level out, as square waves.
> What I need to know is, can I T off the T/Thunderbolt 10MHz feed to
> this board and take a second sine wave output direct from the
> Thunderbolt, to drive a transceiver GPS disciplined 10 MHz frequency
> standard input as well as having it feed the divider baord, which has
> a square wave output? Thanks.
> 
> The .pdf for David's board is at:
> 
> http://www.google.com/url?sa=t&rct=j&q=&esrc=s&source=web&cd=4&ved=0CDMQFjAD&url=http%3A%2F%2Fwww.perdrix.co.uk%2FFrequencyDivider%2FFrequency%2520Divider%25202.1.pdf&ei=g5AVVbDXGcSy7QbLioCAAQ&usg=AFQjCNHiXeXt-NZksvMBKYHfkJPf5mn_Fw&sig2=kXB0iLgZhoDuB8shplLFqA&bvm=bv.89381419,d.ZGU?

-- 
WBW,

V.P.