[time-nuts] TimeLab + sr620

[lincoln]

Hello Magnus,
	It was a baud rate issue. Time Monitor defaults to 9600 and Time Lab uses 19200. Changed the counter and time monitor to use 19.2k and every body is happy. 

	Now I have to figure out how to use time lab. My TIE plots just show as a strait line, I can zoom in to show detail but the y scale will go form +1.00E0 to  +1.00E0 . I'm sure its a setting.

Thank you


On May 4, 2015, at 10:40 PM, Magnus Danielson <magnus at rubidium.dyndns.org> wrote:

> Lincoln,
> 
> Did you configure the coulder to use RS232 rather than GPIB?
> It's in the manual.
> 
> Cheers,
> Magnus
> 
> On 05/04/2015 07:28 AM, lincoln wrote:
>> Hello,
>> 	I've taken a first pass at using TimeLab over the weekend. I wasn't able to get it to work with my SRS sr 620 over RS232.   I know that the com port / serial cable and counter are working. I can open terminal, talk to the counter, and make a measurement. When I setup a measurement in TimeLab If I hit  the "monitor" button I don't see any activity. If I start the measurement, Time lab never gets past trying to establish communication with the counter. I'm sure its my fault.
>> 
>> Any thoughs?
>> 
>> thanks
>> 
>> Lincoln
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>> 
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.