[time-nuts] Distributiuon Amlifier Altinex DA1804NT

[jerry shirᴀr]

I know some manufacturers use pot core transformers on the output signal.
HP does it for sure.  Any vibration or shock transforms right into the
phase error of the signal.  IMO, those distribution amps should be avoided
as any level of shock or vibration will contribute to jitter.

On Thu, May 28, 2015 at 3:28 PM, cfo <xnews5 at luna.dyndns.dk> wrote:

> On Thu, 28 May 2015 14:09:36 -0400, Vlad wrote:
>
> >
> > I am not sure what to blame. ;-)
>
> I'm using a TB on a 350Mhz video amplifier 6xRGB , and discovered that
> the Video DistAmp was clipping the 10Mhz from the TB.
>
> I used a 10dB attenuator on the TB signal (6dB would have been better) ,
> but i had a 10dB in the drawer.
>
> Watch out for putting a too high signal into a 1V-PP Video Dist Amp.
>
> CFO
> Denmark
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>