[time-nuts] HP 53132A Display
Philip Zahariev
philip_zahariev at yahoo.com
Fri Apr 1 20:23:28 UTC 2016
Hi Bert,
Disconnect filament from PCB (one end is enough) and connect to regulated DC Power supply. Adjust voltage to 8V and current to 0.3-0.4A. In a dark room should see very small red light. Slowly increase little bit voltage until color goes to orange-yellow. Important - do not move display during procedure. Keep filament powered for 5-7 min and after that reconnect filament to PCB. Power on counter and share result.
Best regards
Philip
Sent from my iPhone
> On 1.04.2016 г., at 22:14, Bert Kehren via time-nuts <time-nuts at febo.com> wrote:
>
> Did buy a HP53132a counter mainly to use with the RS 232 for high
> resolution and to have a backup for my very favorite 5345a with 40 GHz head. Sadly
> the very clean unit has a very weak display to the extend that an 8 looks
> like a 9. Have the option for a full refund but would like to explore
> alternatives. Any ideas.
> Bert Kehren
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list