[time-nuts] 1 PPS 50-ohm driver
wb6bnq
wb6bnq at cox.net
Sun Apr 17 14:26:00 UTC 2016
Hi Douglas,
Blowing up the picture shows some lettering in the white bar at the
bottom of the display (fairly fuzzy). It looks like it is saying 2
volts for the signal with the scope set to 0.5 volts per division.
Bill....WB6BNQ
Douglas Bercich wrote:
>I was looking but can't find a V/div anywhere on that. Maybe my old eyes or not enough coffee. 500mV?
>
>
>
>>On Apr 16, 2016, at 11:58 PM, Stewart Cobb <stewart.cobb at gmail.com> wrote:
>>
>>Here's a scope photo from a PPS driver built exactly to the description in
>>my earlier post. It's a 74ACT04 in a TSSOP package, with five parallel
>>outputs driving five 220-ohm resistors (0402 SMT) to form a 50-ohm output.
>>
>>The photo shows 2 ns rise time for the leading edge of the pulse. The scope
>>bandwidth is around 1 GHz, so this measurement is pushing its limits. The
>>pulse looks fairly clean, but with a bit more care in layout and cabling,
>>it might get even better.
>>
>>Cheers!
>>--Stu
>><IMG_20160416_213804.jpg>
>>_______________________________________________
>>time-nuts mailing list -- time-nuts at febo.com
>>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>>and follow the instructions there.
>>
>>
>_______________________________________________
>time-nuts mailing list -- time-nuts at febo.com
>To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>and follow the instructions there.
>
>
>
More information about the Time-nuts_lists.febo.com
mailing list