[time-nuts] SR620 testing
Bob Camp
kb8tq at n1k.org
Tue Feb 23 12:13:24 UTC 2016
Hi
You may have cleaned up a dirty pot wiper as well …
The SR620 has X/Y outputs? Who knew? … that’s how often that feature
gets used around here.
Bob
> On Feb 23, 2016, at 12:14 AM, Joseph Gray <jgray at zianet.com> wrote:
>
> Ignore the problem with EXT trigger. I did a factory reset and now it
> is working. I should have thought to reset it to begin with.
>
> Joe Gray
> W5JG
>
>
> On Mon, Feb 22, 2016 at 8:14 PM, Joseph Gray <jgray at zianet.com> wrote:
>> Finally got an SR620 at a decent price. I'm going through the
>> Functional Tests and the Performance Tests now. So far, I have two
>> anomalies.
>>
>> Pg 62 Functional Test - EXT input. When I vary the EXT trigger knob, I
>> don't get the trigger LED, except that it flashes briefly at one spot
>> as I move the knob from high to low.
>>
>> XY outputs - text at the top is slanted and text near the middle right
>> is overlaid. I don't know if I care about this, as I am unlikely to
>> use this feature.
>>
>> I can't test the printer port. No Epson printer. I probably don't care
>> about this, either.
>>
>> Pg 63 Performance Test - Timebase frequency is 15 Hz high. I will adjust later.
>>
>> Timebase accuracy +/- 0.0035 Hz passes.
>>
>> This is far as I have gotten. After I get a bite of dinner, I will proceed.
>>
>> The EXT trigger test not working worries me. Perhaps I am doing something wrong?
>>
>>
>> Joe Gray
>> W5JG
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list