[time-nuts] Divider circuit for Rubidium Standard
bruce.griffiths at xtra.co.nz
Sat Jan 9 16:36:35 EST 2016
Splitting the resistor in 2 and ac coupling the emitters together reduces the effects of Vbe and/or base biasing mismatch allowing a more symmetric output and/or operation at lower input signal levels.The inductor reduces the high frequency variations in the total emitter current. It also reduces the tail current noise at high frequencies.
On Sunday, 10 January 2016 10:05 AM, Attila Kinali <attila at kinali.ch> wrote:
Yes, I know I am comming back to an "old" discussion, but I have questions
that need to be answered! :-)
On Wed, 06 May 2015 08:56:10 -0400
John Ackermann N8UR <jra at febo.com> wrote:
> Wenzel has published the schematic of an excellent squaring circuit. I
> don't have the URL for their version handy, but I used it (with a couple
> of mods) in the TADD-2 and TADD-2 Mini designs. You can see the
> schematic in the T2-Mini users guide at
The manual says:
The purpose of the input circuit is to convert the RF input signal
into a low-jitter square wave that can drive the PIC clock input.
The circuit is closely based on the one published by Wenzel at
http://www.wenzel.com/documents/waveform.html, with modifications
suggested by Bruce Griffiths and Ulrich Bangert. The revised circuit
works with inputs as low as -20dBm.
The modification I can see is that the "current source" part of the
differential pair changed from being a single, shared resistor of 100R to
an inductor of 100uH, then splits up into two resistors of 220R,
which are bridged by a 100nF capacitor. The inductor results in a
reactance between 62R (100kHz) and 12k (20MHz) for the input range.
Can you shed a bit of light on why you did those modifications
and what the intended effect is?
It is upon moral qualities that a society is ultimately founded. All
the prosperity and technological sophistication in the world is of no
use without that foundation.
-- Miss Matheson, The Diamond Age, Neil Stephenson
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the time-nuts