[time-nuts] Valpey-Fisher VFT22H OCXO Output

Grant Hodgson grant at ghengineering.co.uk
Sat Jan 30 13:11:14 EST 2016


Logan

It looks alright to me - it's a sine wave output with some 2nd and 
higher order harmonics, nothing unusual there.

If you want a cleaner output then an external low pass filter will soon 
clean it up.

regards
Grant


From: Logan Cummings <logan.cummings at gmail.com>
To: time-nuts at febo.com
Subject: [time-nuts] Valpey-Fisher VFT22H OCXO Output
Message-ID:
	<CA+98HASCx7+S9uZJVS+dc4hDmLFNzdaY7y0z98UjTXspbs+c_w at mail.gmail.com>
Content-Type: text/plain; charset="utf-8"

Hi All,

      Curious what could give this waveform (attached) - I presume this is
not correct output for this oscillator (surplus/salvage from Harris
Constellation receiver).

      Frequency looks OK with +2V EFC but output looks like neither sine nor
any CMOS I've seen into 10Mohm (first capture, scope probe alone) or 50ohm
(50ohm term at SMA connector, probed by same scope probe) .

      What gives? If I open up the can, what am I looking to possibly
replace/eliminate? How to open it? It's soldered shut (2x2in case).

      I need a good low-noise 100MHz sine wave for my application so I'm
tempted to open this guy up and replace the output circuitry with something
more suitable.

     Thanks in advance for any pointers/info on these units!
-Logan



More information about the time-nuts mailing list