[time-nuts] Clock Block Unavaliable - Alternative Solutions ?

[Joseph Gray]

Take your pick:

http://www.mouser.com/Search/Refine.aspx?Keyword=idt+loco

Joe Gray
W5JG


On Fri, Jun 3, 2016 at 12:26 PM, Mike Cook <michael.cook at sfr.fr> wrote:
> As you only want one frequency you could use the ICS525 which I think the clock block uses and hardwire the relevant select pins.
> There is a calculator (windows only) available on the IDT site <http://www.idt.com/document/swt/525-01020304-and-307-02-calculator-tool >
> which gives input pin settings. 24MHz can be got from 10MHz input with 0ppm error.
> Probably best to set it up on a cape.
>
> Hope that helps.
>
>> Le 3 juin 2016 à 16:15, Iain Young <iain at g7iii.net> a écrit :
>>
>> Hi All,
>>
>> I noticed that the TAPR site now lists the Clock-Block as unavaliable.
>>
>> This is a shame as I was going to experiment with driving some beaglebones
>> with a 24MHz clock from one, multiplied up from a Rb/GPS/LORAN source this
>> summer
>>
>> Does anyone know of a similiar device avaliable elsewhere (built) ? Or
>> are there plans for a clock block v2 ?
>>
>> I guess I can drive them at 10MHz directly, but it would have been great
>> to push them at 24MHz, however using a HP Signal Generator locked to
>> one of my references seems...overkill :)
>>
>>
>> Iain
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>
> "The power of accurate observation is commonly called cynicism by those who have not got it. »
> George Bernard Shaw
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>