[time-nuts] A Symmtricom GPSDO Board
Bruce Griffiths
bruce.griffiths at xtra.co.nz
Sun Jun 5 08:35:39 UTC 2016
Perhaps a location for an alternate receiver used in another model/version that shared the same PCB albeit populated with different OCXOs etc?.
Interesting that 2 ocxos appear to be in use.
Bruce
On Sunday, 5 June 2016 5:53 PM, Charles Steinmetz <csteinmetz at yandex.com> wrote:
Isn't the GPS receiver the Furuno GT-8031F timing module in the upper
right corner?
Charles
Bruce wrote:
> More likely the missing GPS receiver board is installed over the ground plane.
> Bruce
>
>
> On Sunday, 5 June 2016 4:11 PM, Hui Zhang <ba6it at 163.com> wrote:
>
>
> Dear group:
> Does anyone familiar with this Symmtricom GPSDO board? I have searched on internet but I have not found any manual or technical infomation about it. It seems can use a RS-232 cable and simple SCPI or serial command to control it, just like HP 58540 or other GPSDO board that I had, and there is a blank place on PCB that seems can install a big OCXO or SUB-Board? I don't sure, so I would like to find more detail of this board, it has a reasonable price so I can get one. Any information will be appreciated.
>
>
> Here is the some pictures.
> http://www.dz98.com/tp/an78-3.jpg
> http://www.dz98.com/tp/an78-1.jpg
_______________________________________________
time-nuts mailing list -- time-nuts at febo.com
To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list