[time-nuts] OT stuffing boards: was GPS interface/prototyping
Bob Camp
kb8tq at n1k.org
Fri Jun 24 02:33:33 UTC 2016
Hi
Both the T962 and the T962A’s work ok. You need to re-tape them and re-flash the
firmware. They *are* IR reflow machines and you have to design with that in mind. The IR
process has never been a good idea for 85C rated black cased plastic capacitors. Is it
better or worse than a converted toaster? That depends on how much work you did on
the toaster…..
If you simply want a more plug and play with less thinking involved, machine there are others up
in the $1500 to $2000 range.
I’ve been doing SMT assembly for 40 years. I have never ever seen anybody with a process
that “just worked”. They all involve some amount of fine tuning and design optimization.
Bob
> On Jun 23, 2016, at 9:28 PM, Jay Grizzard <elfchief-timenuts at lupine.org> wrote:
>
> On Thu, Jun 23, 2016 at 11:28:00PM +0000, Mark Sims wrote:
>> A usable re-flow oven can be had for $300.
>
> Do you (or anyone) have suggestions for usable reflow ovens in this price
> range? Every time I've gone looking on Amazon, I've found ovens which
> (according to reviews) had cycle timers were *horribly* off, to the point
> they would sometimes burn boards by keeping them at peak temperature
> for 2x - 3x as long as they were programmed to. Though you can work
> around that if you really want to, this really doesn't meet my definition
> of "usable".
>
> Am I missing some obvious cheapie oven without these types of problems?
>
> -j
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the Time-nuts_lists.febo.com
mailing list