[time-nuts] Capturing a 1PPS signal with a Keysight 53230A
Tom Van Baak
tvb at LeapSecond.com
Mon May 2 18:12:28 UTC 2016
> * DC
> * 50Ohm
> * Bandwidth filter enabled
DC and 50R is ok. I would not use the filter; you want the fastest edge possible.
You forgot to mention the most important setting of all - the trigger voltage. Check the signal at your inputs with a 'scope. I typically use 1.0 VDC, unless the 'scope suggests otherwise.
You should expect a risetime of a few ns. If it's a lot more something's wrong and it will affect your ublox vs. Rb conclusions.
/tvb
More information about the Time-nuts_lists.febo.com
mailing list